ZDX V6-3.7L (2010)
Engine Control Module: Service and Repair
PCM Replacement
Special Tools Required
-
Honda Diagnostic System (HDS) tablet tester
-
Honda Interface Module (HIM) and an iN workstation with the latest HDS software version
-
HDS pocket tester
-
GNA600 and an iN workstation with the latest HDS software version
Any one of the above updating tools can be used.
NOTE: Make sure the HDS/iN workstation has the latest HDS software version.
1. Connect HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
2. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
3. Make sure the HDS communicates with the PCM and all other vehicle systems. If it doesn't, go to the DLC circuit troubleshooting See:
Powertrain Management/Computers and Control Systems/Testing and Inspection/Component Tests and General Diagnostics/DLC Circuit
Troubleshooting. If you are returning from the DLC circuit troubleshooting, skip steps 5 through 9, 18 through 23, and 26 through 28, and do this
after replacing the PCM:
-
Replace the engine oil See: Engine, Cooling and Exhaust/Engine/Engine Lubrication/Engine Oil/Service and Repair and the engine oil filter
See: Engine, Cooling and Exhaust/Engine/Engine Lubrication/Oil Filter/Service and Repair.
-
Replace the ATF See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and Replacement/ATF
Replacement.
-
Clean the throttle body See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and Repair/Procedures.
4. Select the PGM-FI system with the HDS.
5. Select the INSPECTION MENU with the HDS.
6. Select the ETCS TEST, then select the TP POSITION CHECK, and follow the screen prompts.
NOTE: If the TP POSITION CHECK indicates FAILED, continue with this procedure.
7. Select the REPLACE PCM MENU, then select READ DATA, and follow the screen prompts.
NOTE:
-
Doing this step copies (READS) the engine oil life data from the original PCM so you can later download (WRITES) it into the new PCM.
-
If the READ DATA indicates FAILED, continue with this procedure.