ZDX V6-3.7L (2010)
Front Passenger's Weight Sensor Output Check After a Vehicle Collision
1. Position the front passenger's seat to the rear most position, and adjust the seat-back to the forward most position. Do not move the seat from this
position until the output check is completed.
2. Drive the vehicle, accelerate to 22 mph (36 km/h), then stop on level ground.
3. Make sure the ignition switch is in LOCK (0), or press the engine start/stop button to select the OFF mode.
4. Connect the HDS to the data link connector (DLC) (A).
5. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
6. Make sure the HDS communicates with the vehicle and the SRS unit. If it does not communicate, troubleshoot the DLC circuit See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Component Tests and General Diagnostics/DLC Circuit Troubleshooting.
7. From the HDS Main Menu, select SRS, then Inspection. In the Inspection Menu, select AFTER A VEHICLE COLLISION. Follow the prompts
until the front passenger's weight sensor output check has been completed.
8. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
9. Disconnect the HDS from the DLC.
