ZDX V6-3.7L (2010)
2. Connect the driver's seat position sensor 2P connector (D) on the driver's seat wire harness.
3. Do the battery terminal reconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
4. Clear any DTCs with the HDS See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
5. Check the operation of the driver's seat position sensor with the HDS See: Testing and Inspection/Component Tests and General
Diagnostics/Driver's Seat Position Sensor Operation Check.
6. Confirm proper SRS operation: Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and check that the
SRS indicator comes on for about 6 seconds and then goes off.
7. Reinstall all removed parts.