ZDX V6-3.7L (2010)
-
Inspect all the SRS wire harnesses. Replace, do not repair, any damaged harnesses.
-
Inspect the cable reel for heat damage. If there is any damage, replace the cable reel.
After the vehicle is completely repaired, turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode. If the SRS
indicator comes on for about 6 seconds and then goes off, the SRS is OK. If the indicator does not function properly, use the HDS to check for DTCs
with the HDS See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes. If you cannot retrieve a code, do the SRS
Symptom Troubleshooting.
Checking and Adjusting the Headliner/Pillar Trim Overlap
To prevent the side curtain airbag from deploying and damaging the pillar trim, the overlap between the headliner and pillar trim must be less then 8 mm
(0.32 in) To check the overlap, do this:
1. Install the headliner (A) and the pillar trim (B).
This illustration shows the A-pillar.
2. Apply masking tape to the headliner, mark the upper edge of each pillar trim.
This illustration shows the A-pillar.
3. Remove the pillar trim, and measure the headliner overlap.
-
If the overlap is less than 8 mm (0.32 in), remove the tape, and install the pillar trim.
-
If the overlap is more than 8 mm (0.32 in), go to step 4.
