ZDX V6-3.7L (2010)
Seat Belt Tensioner
10. Remove the B-pillar lower trim See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/Interior Trim
Removal/Installation - Pillar Areas.
11. Disconnect the driver's and the front passenger's seat belt tensioner 4P connectors (A) on the floor wire harness. Pull the seat belt out all the way
and cut it.
12. Cut off each connector, and strip the ends of the wires. Twist each pair of unlike colored wires together, and clip an alligator clip (A) from the
deployment tool to each pair.
NOTE:
-
Place the deployment tool at least 10 m (32 ft) away from the vehicle.
-
The driver's and front passenger's airbags have dual inflators. Twist each pair of unlike colored wires together, and clip an alligator clip to each
pair.
