ZDX V6-3.7L (2010)
Seat Position Sensor: Service and Repair
Driver's Seat Position Sensor Replacement
Removal
NOTE: Do not turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and do not connect the battery cable while
removing the driver's seat position sensor.
1. Raise the driver's seat all the way up.
2. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures, then wait at least 3 minutes
before starting work.
3. Remove the upper rail outer cover See: Body and Frame/Seats/Service and Repair/Front Seat Frame Replacement.
4. Disconnect the driver's seat position sensor 2P connector (A) on the driver's seat wire harness.
5. Remove the TORX bolt (B) and nut (C) using a TORX T30 bit, then remove the driver's seat position sensor (D).
Installation
NOTE:
-
Be sure to install the harness so it is not pinched or interferes with other parts.
-
Do not turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and do not connect the battery cable while
installing the driver's seat position sensor.
1. Install the driver's seat position sensor (A) with a new TORX bolt (B) using a TORX T30 bit, and new nut (C).
