ZDX V6-3.7L (2010)
Trunk / Liftgate Switch: Service and Repair
Tailgate Lock Switch Test/Replacement
Tailgate Lock Switch Test/Replacement
1. Open the tailgate and remove the tailgate lower trim panel .
2. Remove the rear license trim See: Body and Frame/Exterior Moulding / Trim/License Plate Frame/Service and Repair.
3. Disconnect the tailgate lock switch 2P connector (A).
4. Remove the two screws and tailgate lock switch (B).
5. Check for continuity between the terminals in each switch position according to the table.
6. If the continuity is not as specified, replace the switch. If the continuity is as specified, go to step 7.
7. Check for continuity between rearview camera 16P connector terminals No. 7 and No. 8 , and tailgate lock switch 2P connector terminal No. 1 and
No. 2.