ZDX V6-3.7L (2010)
6. Remove the wire harness clips (B), then remove the combination switch assembly/cable reel from the steering column.
7. Remove the cable reel See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair.
8. Remove the combination light switch (A) and the wiper/washer switch (B) from the combination switch body assembly (C).
NOTE: When installing the cable reel, set the turn signal canceling sleeve position so that the arrow points (D) straight up.
9. Install the combination switch body assembly in the reverse order of removal, and note these items:
-
Do not remove the steering angle sensor from the combination switch body assembly.
-
Tighten the combination switch assembly/cable reel mounting screw in the proper sequence See: Steering and Suspension/Steering/Steering
Column/Service and Repair/Steering Column Removal/Installation.
-
Do the VSA sensor neutral position memorization See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Programming and Relearning/VSA Sensor Neutral Position Memorization.
