ZDX V6-3.7L (2010)
Combination Switch: Service and Repair
Combination Light Switch Test/Replacement
1. Remove the steering column covers See: Steering and Suspension/Steering/Steering Column/Steering Column Cover/Service and Repair.
2. Disconnect the dashboard wire harness 12P connector (A) from the combination light switch (B).
3. Remove the two screws, then slide out the combination light switch.
4. Inspect the connector terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, check for continuity between the terminals in each switch position according to the tables.
5. If all the continuity is not as specified, remove the two screws and replace the switch.
6. Install the parts in the reverse order of removal.
