ZDX V6-3.7L (2010)
VEHICLE OFF. With either system, the steering wheel automatically moves fully up to let you know the system has reset.
14. Turn on the radio, and check the channel presets to make sure they are working.
15. If the tailgate was opened while the battery was disconnected, the power tailgate control unit must be reset. With both battery cables attached, reset
the control unit by manually lowering and fully closing the tailgate. Operate the power tailgate to make sure it has reset.
16. Initialize the navigation system (see page 3).
17. To clear the Battery Sensor DTC using the HDS, from the system selection menu:
^
Select BODY ELECTRICAL, then select GAUGES from the sub-system menu.
^
Next, select DTCs and clear the Battery Sensor DTC, using the CLEAR DTCs button.
18. To clear the AcuraLink message:
^
Press and hold MENU, MAP, and CANCEL simultaneously for about 5 seconds until the display changes to the DIAGNOSTIC ITEMS mode.
NOTE:
DO NOT select DATA RESET on this screen; doing so will deactivate the client's AcuraLink account and all its settings.
^
Using the navigation system's interface dial, highlight DETAIL INFORMATION & SETTING, then select it by pressing Enter.
^
Select XM (HIP).
^
Select XM (HIP) DIAG.
^
Select DIAGNOSTIC INFO.
^
Select the Battery Sensor DTC; a message will appear; press Enter. At the "delete DTC" confirmation screen, press Enter, then Yes. The
DTC and AcuraLink display message will be erased.
INITIALIZING THE NAVIGATION SYSTEM
Any time the navigation system loses power, such as through battery disconnection, it must be initialized by doing these procedures, in this order:
^ Entering the Security Code
^ GPS Initialization
^ Map Matching
Entering the Security Code
Turn the ignition switch to ON (II). For ZDX models with the keyless access system, select the ON mode. Enter the client's 5-digit anti-theft security
code.
If the security code is lost or unavailable, you can get it from the iN using the navigation unit's serial number. To get the serial number without removing
the audio-navigation unit, do this:
^ Press and hold the MENU, MAP/GUIDE, and CANCEL buttons at the same time.
^ At the Select Diagnosis Items screen, select Detail Information & Settings > Unit Check > ECU Info.
The system runs a brief diagnosis, then the audio-navigation unit's serial number displays at the bottom of the screen.
^ Use the Anti-Theft Code Inquiry option on the iN to enter the navigation unit's serial number, which will then provide its 5-digit anti-theft code. The
iN may display more than one code for a given serial number. Because serial numbers are not unique, you may have to try entering more than one
5-digit code. If no anti-theft code is shown, or if the codes given do not unlock the audio-navigation unit, call the Honda Automobile Warranty
Department.
GPS Initialization
Depending on the length of time the battery was disconnected, the system may require GPS initialization.
