ZDX V6-3.7L (2010)
Transmission Position Switch/Sensor: Service and Repair
Transmission Range Switch Replacement
1. Do the battery removal procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.
2. Remove the air cleaner See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair.
3. Remove the intake air duct See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and
Replacement/Automatic Transmission Removal.
4. Remove the battery heat shield See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and
Replacement/Automatic Transmission Removal.
5. Remove the auxiliary under-hood fuse/relay box See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and
Repair/Removal and Replacement/Automatic Transmission Removal.
6. Remove the battery base See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and
Replacement/Automatic Transmission Removal.
7. Disconnect the transmission range switch connector.
8. Remove the spring clip (A) and the control pin (B), then separate the shift cable end (C) from the control lever (D).
9. Check the bushing (E) in the shift cable end for a proper fit and wear. If the bushing is loose or worn, replace the shift cable See: Transmission
and Drivetrain/Automatic Transmission/Transaxle/Shift Linkage/Shift Cable/Service and Repair.
10. Remove the nuts (A) securing the shift cable bracket (B).