ZDX V6-3.7L (2010)
Ignition Switch: Testing and Inspection
Ignition Key Switch Test
Ignition Key Switch Test
NOTE: SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations, precautions
and procedures See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair
before doing repairs or servicing.
1. Remove the steering column upper and lower covers See: Steering and Suspension/Steering/Steering Column/Steering Column Cover/Service and
Repair.
2. Disconnect the 6P connector (A).
3. Check for continuity between terminals No. 1 and No. 2.
-
There should be continuity with the key in the ignition switch.
-
There should be no continuity with the key removed.
4. If the continuity is not as specified, the ignition key switch is faulty; replace the steering lock See: Steering and Suspension/Steering/Steering
Column/Steering Column Lock/Service and Repair.