ZDX V6-3.7L (2010)
Seat Occupant Sensor: Service and Repair
Front Passenger's Weight Sensor Replacement
Removal
NOTE:
-
Removal of the front passenger's weight sensors must be done according to Precautions and Procedures See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair.
-
The front passenger's weight sensors is part of the seat frame and must be replaced as a front passenger's seat frame assembly.
1. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures, then wait at least 3 minutes
before starting work.
2. Remove the front passenger's seat frame/front passenger's weight sensors as an assembly See: Body and Frame/Seats/Service and Repair/Front
Seat Frame Replacement.
Installation
NOTE:
-
Be sure to install the harness wires so they are not pinched or interfering with other parts.
-
The front passenger's weight sensor are part of the seat frame and must be replaced as a front passenger's seat frame assembly.
1. Install the removed parts to the new the front passenger's seat frame/front passenger's weight sensors as an assembly See: Body and
Frame/Seats/Service and Repair/Front Seat Frame Replacement.
2. Do the battery terminal reconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
3. Clear any DTCs with the HDS See: Restraint Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
4. Do the front passenger's weight sensor initialization See: Restraint Systems/Air Bag Systems/Testing and Inspection/Programming and
Relearning/ODS Unit Initialization.
5. Confirm proper SRS operation: Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and check that the
SRS indicator comes on for about 6 seconds and then goes off.