ZDX V6-3.7L (2010)
Battery Current Sensor: Customer Interest
Electrical - 'CHECK BATTERY SENSOR' Mssg./DTC B1192
10-012
Applies To:
2010 MDX - From VIN 2HNYD2H..AH5OOOO1 thru 2HNYD2H..AH509654
2010 ZDX - From VIN 2HNYB1H..AH500001 thru 2HNYB1H..AH501670
May 14, 2010
MID Displays CHECK BATTERY SENSOR With DTC B1192 Stored
SYMPTOM
The MID displays CHECK BATTERY SENSOR, and DTC B1192 (gauge control module lost communication with the battery sensor) is stored.
NOTE:
The MID may also display other battery messages. Do not use this service bulletin if the MID displays BATTERY CHARGE LOW or REPLACE
BATTERY.
PROBABLE CAUSE
The battery sensor assembly on the negative battery cable has failed.
CORRECTIVE ACTION
Replace the negative battery cable.
PARTS INFORMATION
Negative Battery (Ground) Cable:
P/N 32600-STX-A01
SPECIAL TOOL
Acura Computer Memory Saver: T/N EZRMS4000A
NOTE:
The Honda version of this special tool, T/N EZRMS4OOOH, was shipped to Acura dealers in 2006.
WARRANTY CLAIM INFORMATION
The normal warranty applies.
Operation Number:
710103
Flat Rate Time:
0.2 hour
Failed Part:
32600-STX-A01
Defect Code:
06801
Symptom Code:
03205
Skill Level:
Repair Technician
DIAGNOSIS
Check that the battery sensor fuse is the correct type and is not blown, and that the battery sensor 2P cable is connected:
^ On MDX, check for a blown No.9 (7.5 A) micro fuse in the main under-hood fuse box.
- If the No.9 fuse is blown, replace it with a 7.5 A micro fuse. Clear the DTC and the MID message, then recheck the system. If the fuse blows again,
troubleshoot its cause.