ZDX V6-3.7L (2010)
Special Tools Required
-
Back Probe Adapter, 17 mm 07TAZ-001020A
-
Make sure the battery is fully charged when doing electrical test. If the battery is not fully charged, the results of the tests may not be accurate.
-
When using electrical test equipment, insert the probe of the tester into the wire side of the connector (except water proof connector). Do not insert
the probe of the tester into the terminal side of the connector, and do not tamper with the connector.
-
Use the back probe adapter, 17 mm (07TAZ-001020A). Do not insert the probe forcibly.
-
Use specified service connectors in troubleshooting.
Using improper tools could cause a diagnostic error due to poor metal-to-metal contact.
SRS Unit Connectors
When diagnosing or troubleshooting at an SRS unit connector (A), use the terminal test port below the terminal you need to check. Gently insert the pin
probes of the tester or jumper wire at the terminal test port from the terminal side.
