ZDX V6-3.7L (2010)
Steering Gear Mount: Service and Repair
Steering Gearbox Mount Cushion Replacement
1. Remove the steering gearbox See: Service and Repair/Removal and Replacement/Steering Gearbox Removal.
2. Position a 34 mm socket (A) on the flange part of the gearbox housing with a washer (B), a 10 x 105 mm flange bolt (C), and a 10 mm nut (D) as
shown.
3. Hold the flange bolt with a wrench, and tighten the nut with a wrench. Remove the gearbox mount cushion (E).
4. Apply a mild soap and water solution to the new gearbox mount cushion surface (A), then place the mount cushion on the gearbox mounting
cushion hole.
5. Position a 34 mm socket (B) on the flange part of the gearbox housing with a washer, a flange bolt, and a nut as shown.
6. Install the gearbox mount cushion by tightening the nut until the mount cushion edge (A) properly fits on the gearbox flange surface (B).