ZDX V6-3.7L (2010)
Ball Joint: Service and Repair
Ball Joint Removal
Ball Joint Removal
Special Tools Required
-
Ball Joint Thread Protector, 12 mm 07AAF-SDAA100
-
Ball Joint Thread Protector, 14 mm 071AF-SZNA100
-
Ball Joint Remover, 32 mm 07MAC-SL0A102
-
Ball Joint Remover, 28 mm 07MAC-SL0A202
NOTICE
Always use a ball joint remover to disconnect a ball joint. Do not strike the housing or any other part of the ball joint connection to disconnect
it.
1. Install a hex nut (A) or the ball joint thread protector onto the threads of the ball joint (B).
NOTE: Using a hex nut, make sure the nut is flush with the ball joint pin end to prevent damage to the threaded end of the ball joint pin.
2. Apply grease to the ball joint remover on the areas shown (A). This will ease the installation of the tool, and prevent damage to the pressure bolt
(B) threads.
3. Loosen the pressure bolt (A), and install the ball joint remover as shown. Insert the jaws carefully, making sure not to damage the ball joint boot.
Adjust the jaw spacing by turning the adjusting bolt (B).
NOTE: Fasten the safety chain (C) securely to a suspension arm or the subframe (D). Do not fasten it to a brake line or wire harness.