ZDX V6-3.7L (2010)
6. Release the parking brake lever fully, and remove the rear brake disc/drum See: Brakes and Traction Control/Disc Brake System/Brake
Rotor/Disc/Service and Repair/Rear Brake Disc Replacement.
7. Remove the hub bearing unit (A).
NOTE: Do not pull the driveshaft end outward. The driveshaft inboard joint may come apart.
8. Check the hub bearing unit for damage and cracks.
9. Install the hub bearing unit in the reverse order of removal, and note these items:
-
Use a new spindle nut during reassembly.
-
Before installing the spindle nut, apply a small amount of engine oil to the seating surface of the nut. After tightening, use a drift to stake the
spindle nut shoulder against the driveshaft.
-
Before installing the brake disc/drum, clean the mating surfaces of the hub bearing unit and the inside of the brake disc/drum.
-
Before installing the wheel, clean the mating surfaces of the brake disc/drum and the inside of the wheel.
10. Check the wheel alignment, and adjust it if necessary See: Alignment/Service and Repair.
Knuckle Replacement
1. Remove the hub bearing unit.
2. Remove the brake hose bracket mounting bolt (A) from the knuckle.
