ZDX V6-3.7L (2010)
6. Remove the front brake disc See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Front Brake Disc
Replacement.
7. Remove the flange bolts (A), and remove the hub bearing unit (B) by tapping the driveshaft end (C) with a soft face hammer while drawing the
hub bearing unit outward, then remove the splash guard (D).
NOTE:
-
Do not pull the driveshaft end outward. The driveshaft inboard joint may come apart.
-
During installation, apply grease to the mating surfaces of the hub bearing unit and driveshaft outboard joint See: Transmission and
Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal and Replacement/Front Driveshaft Installation.
8. Check the hub bearing unit for damage and cracks.
9. Install the hub bearing unit in the reverse order of removal, and note these items:
-
Use the new spindle nut during reassembly.
-
Before installing the spindle nut, apply a small amount of engine oil to the seating surface of the nut. After tightening, use a drift to stake the
spindle nut shoulder against the driveshaft.
-
Before installing the brake disc, clean the mating surfaces of the hub bearing unit and the inside of the brake disc.
-
Before installing the wheel, clean the mating surfaces of the brake disc and the inside of the wheel.
10. Check the wheel alignment, and adjust it if necessary See: Alignment/Service and Repair.
Knuckle Replacement
