ZDX V6-3.7L (2010)
Fluid Pressure Sensor/Switch: Service and Repair
Transmission Fluid Pressure Switch C (4th Clutch) Replacement
Transmission Fluid Pressure Switch C (4th Clutch) Replacement
1. Raise the vehicle on a lift, or apply the parking brake, block both rear wheels, and raise the front of the vehicle. Make sure it is securely supported.
2. Remove the engine undercover (A) and the front splash shield (B).
3. Disconnect the transmission fluid pressure switch C (4th clutch) connector, and remove transmission fluid pressure switch C (4th clutch) (A) and
the sealing washer (B).
4. Install a new transmission fluid pressure switch C (4th clutch) and a new sealing washer, and tighten the switch.
5. Check the connector for rust, dirt, or oil, and clean or repair if necessary, then connect the connector securely.
6. Install the front splash shield and the engine undercover.
