ZDX V6-3.7L (2010)
Fluid Pressure Sensor/Switch: Service and Repair
Transmission Fluid Pressure Switch E (6th Clutch) Replacement
Transmission Fluid Pressure Switch E (6th Clutch) Replacement
1. Do the battery removal procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.
2. Remove the air cleaner See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair.
3. Remove the intake air duct See: Service and Repair/Removal and Replacement/Automatic Transmission Removal.
4. Remove the battery heat shield See: Service and Repair/Removal and Replacement/Automatic Transmission Removal.
5. Remove the auxiliary under-hood fuse/relay box See: Service and Repair/Removal and Replacement/Automatic Transmission Removal.
6. Remove the battery base See: Service and Repair/Removal and Replacement/Automatic Transmission Removal.
7. Disconnect the transmission fluid pressure switch E (6th clutch) connector, and remove transmission fluid pressure switch E (6th clutch) (A) and
the sealing washer (B).
8. Install a new transmission fluid pressure switch E (6th clutch) and a new sealing washer, and tighten the switch.
9. Check the connector for rust, dirt, or oil, and clean or repair if necessary, then connect the connector securely.
10. Install the battery base See: Service and Repair/Removal and Replacement/Automatic Transmission Installation.
11. Install the auxiliary under-hood fuse/relay box See: Service and Repair/Removal and Replacement/Automatic Transmission Installation.
12. Install the battery heat shield See: Service and Repair/Removal and Replacement/Automatic Transmission Installation.
13. Install the intake air duct See: Service and Repair/Removal and Replacement/Automatic Transmission Installation.
14. Install the air cleaner See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair.
15. Do the battery installation procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.