ZDX V6-3.7L (2010)
14. Connect a jumper wire from the negative battery terminal to shift solenoid valve A or B connector terminal No. 1, and connect another jumper
wire from the positive battery terminal to connector terminal No. 2.
-
If a clicking sound is heard, repair the wire between the PCM connector terminal and the defective shift solenoid valve, then go to step 15.
-
If no clicking sound is heard, replace the secondary valve body, then go to step 15.
15. Install the secondary valve body See: Service and Repair/Overhaul/Valve Body/Secondary Valve Body Replacement.
16. Install the starter See: Service and Repair/Removal and Replacement/Automatic Transmission Installation.
17. Install the ATF dipstick.
18. Install the battery base See: Service and Repair/Removal and Replacement/Automatic Transmission Installation.
19. Install the auxiliary under-hood fuse/relay box See: Service and Repair/Removal and Replacement/Automatic Transmission Installation.
20. Install the battery heat shield See: Service and Repair/Removal and Replacement/Automatic Transmission Installation.
21. Install the intake air duct See: Service and Repair/Removal and Replacement/Automatic Transmission Installation.
22. Install the air cleaner See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair.
23. Do the battery installation procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.