ZDX V6-3.7L (2010)
-
Do not overheat the painted surface around the retainers.
-
To keep the exterior plastic parts near the A-pillar from being overheated by a heat gun, wrap them with an aluminum foil.
2. Using isopropyl alcohol on a shop towel, clean the body bonding surface. After cleaning, keep oil, grease, and water from getting on the surface.
3. Install the retainers (A, B).
1. Peel the adhesive backing away from the retainers.
2. Line up the retainers A with the alignment marks (C) on the body, and attach them with the adhesive tapes (D).
3. Attach the retainer B to the front fender tab (E) with the adhesive tape (F) as shown.
4. Apply epoxy two-part adhesive (G) around the edge of the retainers as shown.
