100 Quattro Sedan L5-2309cc 2.3L SOHC (NF) (1989)
-
Remove acorn nut A, take off bolt B
-
Pull seat adjustment handle to release retaining rod C from seat guide
-
Push seat to rear and out of seat tracks
-
Tilt seat back for access to electrical connectors under seat
-
Disconnect all electrical connectors to seat
-
Tag wires for proper identification
-
Remove seat assembly from vehicle and place on workbench
-
Remove plastic rear backrest cover of front seat
-
Remove side trim panel covers from seat cushion
-
Remove backrest assembly
-
Loosen seat cover from seat cushion
-
Remove upholstery clips and seat cover
Fig 3. Heating Element Replacement
CAUTION
(chart 5 and 6) DO NOT cut into leather seat cover, DO NOT cut closer than ( a ) to seat cover seam. ( a )=5.0 mm (13/64 in.)
-
Cut off old element side panels (as shown) in Fig 3.
Fig 4. Heating Element Replacement
-
Cut out top cover, foam padding and old element from center section, as shown in Fig 4.
Heated seat element, installation