100CS Quattro Wagon V6-2.8L (AAH) (1992)
12 - Bolt w/washer
40 Nm (30 ft lb)
13 - Impact absorber, left
14 - Bolt w/washer
23 Nm (17 ft lb)
15 - Impact absorber, right
16 - Nut w/washer
23 Nm (17 ft lb)
17 - Bumper w/cover
Removing:
-
Remove fog light assembly, where applicable
-
Remove retaining clip -20-
-
Remove trim -25-
-
Remove bolts w/washer -24-
-
Unclip bumper ends from guide piece
-
Remove bumper ends downward and out of guide piece
-
Pry bumper ends over wheel opening and remove toward front
Installing:
-
Carefully pry bumper over edge of wheel opening
-
Guide bumper onto impact absorbers and into guide piece
Note: Bumper ends must be pushed as far as possible up to wheel opening. They may be adjusted in or out by turning the inside tube of
impact absorber. One turn of tube will alter distance 1.0 mm (0.039 in.). After adjustment trim strips must be adjusted to fit bumper.
-
Install bolts w/washer -2-
-
Install trim -25-
-
Install clip -20-
-
Install fog light assembly, when applicable
18 - Towing eye
19 - Protective tubing
20 - Clip
21 - Fog light assembly
‹› When applicable
22 - Washer
23 - Screw
1.0 Nm (9 in lb)
24 - Bolt w/washer
23 Nm (17 ft lb)
25 - Trim
Fig. 1 - Removing Front Bumper, Left And Right Trim
-
Remove front bumper trim while unlocking tabs with plastic putty knife.