100S Quattro Wagon (Canada) V6-2.8L (AAH) (1992)
^
turn screw until each hole is threaded, then remove screws
^
unfasten tie wraps holding telephone wiring harness
^
reposition harness so that telephone connector reaches bracket mounting location
^
leave enough slack at end of harness to fit over trunk liner
^
refasten wiring harness with tie wraps
^
place chalk or marking paint directly onto holes just drilled on left inner trunk wall
^
reinstall left side trunk liner, front edge first
^
with liner properly installed, press liner firmly over holes so that back of liner is marked
^
pull back trunk liner and cut a 13 mm (1/2 in.) diameter hole at each mark
^
reinstall trunk liner ensuring telephone harness connector, fuse connector and antenna cable connector are exposed over top of liner
^
attach two self-adhesive rubber cushions to inside corners of transceiver mounting bracket
^
attach one self-adhesive rubber cushion to flat side of transceiver housing (in the center) where transceiver meets mounting bracket
^
attach final self-adhesive rubber cushion on opposite flat side of transceiver (in the center) where transceiver meets trunk wall
^
attach multi-point connector to transceiver ensuring fuse (arrow) is exposed
^
attach antenna cable to transceiver
^
place mounting bracket over transceiver
^
mount transceiver and bracket so that connectors face forward and transceiver connector wiring points up
^
install mounting bracket securing screws and tighten
^
reinstall trunk liner securing caps
^
fold back trunk carpeting