200 Quattro Wagon L5-2226cc 2.22L SOHC Turbo (MC) (1989)
Sunroof / Moonroof Motor: Adjustments
Electrical drive, checking/adjusting
Note: Check electrical drive positioning with sunroof motor installed.
^ detach sunroof lid headliner and slide back into roof
^ remove cover to sunroof motor
^ open sunroof 50 mm to rear (never to the tilt position) and close
^ tab A on cable drive gear must align with hole B in motor cam
Note: When these points are aligned, the sunroof motor is in the "0" position
If the motor is not in the "0" position after opening and closing,
^ adjust motor to "0" position
Adjusting
Note: This adjustment can only be done with the sunroof motor removed.
^ remove sunroof motor
^ disengage sunroof motor from drive gear by moving lever B in direction of arrow cast on motor
^ insert hand crank or 4mm inside hex wrench into drive pinion A
^ turn drive pinion (to right only) with crank or wrench until the pin on the sunroof stop switch (closed position) falls into the recess of the motor
cam (arrow)