200 Quattro Wagon L5-2226cc 2.22L SOHC Turbo (MC) (1989)
Fig. 6 Steering Rack, Installing
-
guide steering rack with mounting sleeve into housing
-
tap end of rack with plastic hammer to install
-
remove end tube and mounting sleeve 3086/2A
Fig. 7 End housing oil seal/O-ring, removing
-
use an extractor such as Kuko no.21/4 (arrow) or pry out end housing oil seal and 0-ring
Fig. 8 End housing oil seal, installing
-
replace end housing 0-ring and drive in seal until seated
-
install end housing onto steering gear housing but do not torque bolts
-
slide piston, piston seal and shims onto piston rod and install but do not tighten nut