audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

All Other Service Bulletins for Fuel Shut-off Solenoid:|879201|Page 3540 > < All Other Service Bulletins for Fuel Shut-off Solenoid:|879201|Page 3538
Page 1
background image

Fuel Shut-off Solenoid: Testing and Inspection

Requirements:

-

engine cold

-

connect tester according to manufacturer's instructions

NOTE:  TDC sensor must be fully seated into transmission housing.

-

use additional connector (local supply) to attach test wire onto ignition coil terminal (arrow)

-

push back rubber boot of connector for cut-off valve

-

attach multimeter US 1119 to connector contact

-

turn ignition ON

-

specification: 0.0 volts DC 

IF OK:

-

replace the cutoff control unit

All Other Service Bulletins for Fuel Shut-off Solenoid:|879201|Page 3540 > < All Other Service Bulletins for Fuel Shut-off Solenoid:|879201|Page 3538