5000CS Turbo L5-2226cc 2.22L SOHC Turbo (MC) (1987)
Paint: All Technical Service Bulletins
Paint - Industrial Fallout Removal (Revised)
Group: 50
Number: 94-01
Date: February 10, 1994
Subject:
Industrial fallout, removal from paint finish
Model(s):
All models, All model years
This Technical Bulletin supercedes Technical Bulletin, Group 50, No. 93-O2, August 31, 1993.
Condition
Industrial fallout consists of small airborne, mostly metallic particles that settle onto the paint surface. Rubbing your hand across the clean surface will
reveal a gritty texture.
Vehicles damaged by industrial fallout can be restored using the procedure described in this Technical Bulletin.
Service
WARNING
Before using any chemicals or cleaning compounds, carefully read all of the cautions and medical information on the container. Always follow all of
the manufacturer's recommendations.
The following three steps MUST be followed IN SEQUENCE to restore contaminated paint finish.
Use ONLY the specified materials.
Note
Use separate wash mitts and towels for each step. Do not mix mitts/towels or Finish Kare(R) products.
Step 1: Surface preparation and particle removal
-
Wash vehicle, use Finish Kare(R), Product No. 1119 (locally available) and water
^ ratio:
4 parts water
1 part Finish Kare(R) 1119
-
Apply Finish Kare(R) 1119 solution to entire vehicle using a clean, dry wash mitt. Start at bottom of vehicle and work up to top surfaces.
CAUTION
Keep vehicle surfaces wet with the solution at all times. Do not allow the product to dry on the vehicle or to streak down the sides.
-
After all panels have been wetted, agitate surfaces using a clean towel. Reapply solution during agitation.
-
Keep vehicle wet with solution for 3 to 5 minutes
-
Power/pressure wash vehicle with cold water
-
Dry vehicle
Step 2: Particle and Oxidation Removal
-
Apply fallout remover, Finish Kare(R) Product No. 883 (locally available) to affected areas
-
Apply remover to entire vehicle using a clean wash mitt
CAUTION
Keep vehicle surfaces wet with the solution at all times. Do not allow the product to dry on the vehicle or to streak down the sides.