5000CS Turbo L5-2226cc 2.22L SOHC Turbo (MC) (1987)
^
grease gear teeth on new rack with lubricant, Part No. AOF 063 000 04
^
install O-ring onto tube (arrow)
^
push short rack assembly into housing until rack gear meshes with pinion
^
rotate pinion as necessary to install four new flange bolts loosely
^
rotate tube so marking on flange and tube are aligned (arrow)
^
tighten flange bolts to 8 N-m (71 in.lb.)
^
install both pipes with enclosed banjo bolts/ O-rings on valve housing and rack tube (top arrows)
^
install spacer (lower arrow)
CAUTION
Note the exact location of pipes (with and without noise damper) and banjo bolts (with and without center punch marks) shown on page 2 and
DO NOT interchange.
^
install boot and new hose clamp
^
tighten cover bolts gradually, alternating between sides until specified torque of 20 N-m (15 ft.lb.) is reached
^
check toe-in (see Group 44)
^
adjust steering play if necessary (see next page)