5000S Wagon L5-2226cc 2.22L SOHC (KZ) (1985)
SENSOR PLATE LEVER BASIC ADJUSTMENT (CONT'D)
-
If measurement is incorrect, adjust CO%: adjusting screw to obtain correct specification
-
Reinstall fuel distributor
-
Recheck sensor plate clearance
-
If OK, readjust idle speed and CO%
-
If not OK, remove fuel distributor and adjust sensor plate clearance with stop screw of control plunger
Clockwise will increase clearance
Counterclockwise will decrease clearance
1/4 turn changes sensor plate position approximately 1.3 mm (.050")
-
Reinstall fuel distributor and check sensor plate height:(Distance a 0.6 mm (0.024 in.) between stop screw and flange of hex nut)
NOTE: After adjustment, readjust idle speed and mA current (CO value) reading.
SENSOR LEVER/SENSOR PLATE CENTERING
The sensor plate must be centered in the air cone. The edges must not touch the sides of the air cone or free movement of the plate will be
restricted