5000S Wagon L5-2309cc 2.3L SOHC (NF) (1988)
Sunroof / Moonroof Motor: Adjustments
Electrical drive, checking/adjusting
Checking
-
remove cover to sunroof motor
-
open sunroof 50 mm (2.0 in) to rear and then close
^ tab A on cable drive gear must align with hole B in motor cam
Note: When these points are aligned, the sunroof motor is in the 0 position
If motor is not in 0 position after opening and closing,
-
adjust 0 position
Adjusting
Note: This adjustment can only be done with sunroof motor removed.
-
remove sunroof motor
-
disengage sunroof motor from drive gear by moving lever B in direction of arrow cast on motor
-
insert hand crank or 4 mm inside hex wrench into drive pinion A
-
turn drive pinion with crank or wrench until the pin on the sunroof stop switch (closed position) falls into the recess of the motor cam (arrow)