5000S Wagon L5-2309cc 2.3L SOHC (NF) (1988)
Hydraulic Brake Servo: Technical Service Bulletins
Removing and Clevis Adjusting Brake Servo
Hydraulic brake servo, removing
Note
Before disconnecting the pressure line at the brake servo:
^
be sure engine is OFF
^
reduce operating pressure by applying brake pedal 20 times, or until pedal-feel hardens
^
remove battery GND (Ground) strap
^
remove strainer from brake fluid reservoir
^
suction out brake fluid from fluid reservoir
WARNING
Brake fluid is poisonous.
CAUTION
Brake fluid is corrosive to painted parts.
^
vehicles with manual transmission ONLY:
^
remove hose (for clutch master cylinder) from brake fluid reservoir
^
disconnect brake fluid level warning sensor
^
remove brake fluid reservoir carefully
disconnect brake lines (arrows) at brake master cylinder
^
seal openings of brake lines and brake master cylinder with plugs
^
disconnect brake master cylinder from brake servo
^
remove brake master cylinder
^
disconnect return line 1 at brake servo