90 L5-2309cc 2.3L SOHC (NG) (1988)
Window Seal: All Technical Service Bulletins
Front Door Window Glass - Rattles
Applies To:
80/90 1988
Subject:
Front Door Window Glass - Rattles
Number:
Group:
88-01
May 20, 1988
64
Door Glass
Modifying front door window glass mounting to prevent rattle
^
remove door trim
^
remove door component carrier
^
remove reinforcement bar
^
install guide pin cap A (beige colored), P/N 893 845 471C at A-pillar, as shown
^
check that guide pin cap B (gray colored), P/N 893 845 471 D was installed at B-pillar, as shown
^
glue on felt stop C (P/N 893 839 491 Left, P/N 893 839 492 Right), as shown, with adhesive D 001 300 or equivalent to window track at
A-pillar
Note
Felt side of strip C must face glass. Tapered end points upward
^
install rubber buffer, P/N 443 877 665C 110 mm (4.3 in.) from rear mounting end of reinforcement bar
^
buffer faces glass
^
using hack saw, cut 6.5 mm (7.64 in.) from both spacers, as shown
^
reinstall all door components in reverse order of removal
CAUTION Part numbers are for reference only. Always check with your Parts Department for latest information.