90 Quattro 20V L5-2309cc 2.3L DOHC (7A) (1990)
^ lift control unit at top (arrow A), and push slightly toward rear (arrow B)
^ press control unit downward at B, and carefully pry out of armrest at C
^ control unit must be first removed at point C to prevent damage to armrest
^ use cloth tape covered plastic wedge to pry out
^ remove control unit in direction of arrow A
^ unplug all electrical connectors from control unit
Installing
Install all components in reverse order of removal, noting the following:
^ reinstall Phillips screw 1
^ 1.5 Nm (1.0 ft lb)
^ reinstall Phillips screws 2 at bottom of control unit
^ 2.5 Nm (2.0 ft lb)
Fig. 6 - Retaining hooks, locations
Door panel trim, cloth separating
Loose cloth trim may be repaired as follows:
^ slightly pull back loose cloth from door panel trim
^ apply adhesive 0 000 801 (with 10% hardened 0 000 802) or equivalent to both cloth and trim panel
^ allow to air dry approximately 10 minutes
^ position cloth trim, and press to door trim panel
^ smooth Out using plastic spatula or similar tool
^ allow to fully harden
^ approximately 30 minutes
CAUTION! Part numbers are listed for reference only. Always consult with the Parts Department for latest information.