90 Quattro 20V L5-2309cc 2.3L DOHC (7A) (1990)
^
DO NOT allow removal solution to dry. Re-apply as needed during hand washing
^
thoroughly rinse the vehicle with clean water to remove the coating and remover solution
^
using towel or chamois, wipe the vehicle dry to prevent water spots
^
if necessary repeat removal procedure until protective coating is completely removed
^
inspect the vehicle for coating not removed. Apply a small amount of the remover solution and then wipe the area with a clean dry cloth
Note
If after removing the coating a dull or hazy finish is left, polish the painted surface with a polishing compound such as "Crystal Shine" by Car Brite(R) or
equivalent and then hand wax using a good quality wax.
Protective transportation coating removal, key points
^
vehicle surface should be at room temperature
^
read all cautions and medical information on container
^
removal of coating is a chemical process and requires use of proper removal solution. VW solutions and other products are not effective
^
DO NOT allow removal solution to dry during removal process
^
rubbing, buffing or other physical activities are not effective