90 Quattro 20V L5-2309cc 2.3L DOHC (7A) (1990)
/Page-3503002.png)
7. 80 Nm (69 ft lb)
Plus additional 1/2 turn (180°). Always replace with new version.
8. Tie rod
Press off with two armed puller. Tightening torque to subframe mount 90 Nm (66 ft lb).
9. Wheel bearing housing
After replacing or loosening mounting bolts, check rear wheel alignment.
10. 40 Nm (30 ft lb)
Always replace.
11. Bolt/washer assembly
120 Nm (89 ft lb) plus 1/4 turn (90°) always replace. Loosen and tighten only with vehicle on ground.
12. Bolt
Always replace (Bolt heads point in drive direction).
13. 65 Nm (48 ft lb)
Always replace.
14. 65 Nm (48 ft lb)
Always replace.
15. Washer
16. Ball Joint
Different part for right and left sides. Offset points to the rear.
17. Locking Plate
18. Bolt
Always replace with new version.
19. Axle Shaft
To remove: Pull ABS sensor out of wheel bearing housing slightly, remove bolt/washer assembly, remove control arm mounting bolts and pull
control arm down.
When installing: Always replace control arm to differential mounting bolts and torque to 65 Nm (48 ft lb).
20. Seal
Remove protective film. Adhesive faces CV joint.
21. Plate Washer
22. 45 Nm (33 ft lb)
