A1
| Exploded view - bonnet |
| 1 - | Bonnet |
| l | When removing or installing the bonnet, a second mechanic is required to support and hold the bonnet. |
| q | Removing: |
| – | Detach gas strut from bonnet → Chapter. |
| – | Unscrew nuts -4- at bonnet hinge at top. |
| – | Detach bonnet. |
| q | Installing: in reverse order of removal |
| q | Adjusting: |
| – | Align bonnet between wings. |
| – | Adjust height of bonnet via bottom section of bonnet lock. |
| – | Adjust position of bonnet to wings via bump stops → Anchor. |
| 2 - | Bolts |
| q | 21 Nm |
| 3 - | Bonnet hinge |
| q | Removing and installing → Anchor |
| 4 - | Nuts |
| q | 21 Nm |
| 5 - | Gas strut |
| q | Removing and installing → Chapter. |
| q | Cylinder end of gas strut is installed on body side. |
| 6 - | Ball-head pin |
| 7 - | Arrester |
| 8 - | Cap nut |
| q | 8 Nm |
| 9 - | Cap nut |
| q | 8 Nm |
| 10 - | Striker |
| Removing and installing striker |
| 1 - | Striker |
| q | When installing, align at sides according to marks -arrow- |
| 2 - | Cap nut |
| q | Tightening torque → Item |
| 3 - | Bonnet |
|
|
|
|
|
| Removing and installing bonnet hinge |
| 1 - | Bonnet hinge |
| – | Remove wheel housing liner → Chapter. |
| – | Before removing hinge, support bonnet or secure it in position. |
| – | Remove gas strut → Chapter. |
| q | Remove bolts -4- and nuts -5- underneath wing. |
| q | Installing: in reverse order of removal |
| 2 - | Nut |
| q | 21 Nm |
| 3 - | Bonnet |
| 4 - | Bolt |
| q | 21 Nm |
| 5 - | Wing mounting flange |
