A1
| Renewing outer sill panel trim |
| 1 - | Sill panel trim |
| q | Removing: |
| – | Heat sill panel trim with a hot-air blower and lift off. |
| q | Installing: |
| – | Side member must be free of dust and grease in bonding area. |
| – | Heat bonding surface on side member to approx. 40° C using hot-air blower. |
| – | Peel protective film off adhesive tape. |
| – | Insert sill panel trim with centring pins into side member and press firmly into place working from front to rear. |
| 2 - | Side member |
| 3 - | Door seal |
| 4 - | Adhesive tape |
| q | Peel off protective film before mounting. |
