A1
Exploded view - exterior door handle and door lock |
1 - | Exterior door handle |
q | Removing and installing → Chapter |
2 - | Bolt |
q | 2.5 Nm |
3 - | Backing plate (front) |
q | Removing and installing → Chapter „Removing and installing exterior door handle“ |
4 - | Backing plate (rear) |
q | Removing and installing → Chapter „Removing and installing exterior door handle“ |
5 - | Housing |
q | Only fitted on passenger door |
q | Removing and installing: same procedures as for lock cylinder → Chapter „Removing and installing lock cylinder“ |
6 - | Bolt |
q | Tightening torque → Item |
7 - | Cap |
q | Clip in |
8 - | Door lock |
q | Only remove and install together with mounting bracket |
9 - | Bolt |
q | 1.5 Nm |
10 - | Cover |
q | For lock cylinder |
q | Removing and installing → Chapter |
11 - | Mounting bracket |
q | Only remove and install together with door lock |
q | Removing and installing → Chapter |
12 - | Operating cable |
q | For door lock |
q | Removing and installing → Chapter |
13 - | Lock cylinder |
q | For driver's door |
q | Removing and installing → Chapter |
14 - | Magnet |
q | Vehicles with keyless entry system only |
15 - | Cap |
q | Driver side: for lock cylinder |
q | Passenger side: closed design |
q | Removing and installing → Chapter |
16 - | Trim for exterior door handle |
q | For vehicles without Keyless Entry system |
q | Removing and installing → Chapter |
17 - | Contact sensor for front left exterior door handle -G605- |
q | For vehicles with Keyless Entry system |
q | Removing and installing → Chapter |
|