audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Replacing seat pan frame > < Exploded view of Easy Entry facility

A1

Removing and installing Bowden cable for easy entry facility
Removing and installing Bowden cable for easy entry facility
Removing
  WARNING
t  Heed the safety regulations for pyrotechnic components → Chapter.
t  Before handling pyrotechnic components (for example to unplug the connector), the person concerned must „discharge static“, for instance by briefly grasping hold of the door striker plate.
–  With the ignition switched off, disconnect the battery earth wire → Rep. gr.27.
–  Remove the front seat → Chapter.
–  Attach the front seat to the seat repair stand -VAS 6136- → Chapter.
–  Remove the trim on the sill panel side → Chapter.
   
–  Remove the cover for the backrest fitting on the sill panel side → Chapter.
–  Disengage the support bracket -4- of the Bowden cable for the easy entry facility from the holder -1- at the seat pan frame.
–  Disengage the Bowden cable for the easy entry facility -2- at the backrest fitting -3-.
  A72-11456
–  Disengage the support bracket -1- of the Bowden cable for the easy entry facility from the holder -2- at the seat fore-and-aft adjuster.
–  Disengage the Bowden cable for the easy entry facility -4- at the seat fore-and-aft adjuster -3-.
–  Unclip the holder -6- for the Bowden cable for the easy entry facility at the seat pan frame.
–  Use a screwdriver to release the retainer tabs -7- and disengage -arrow- and detach the Bowden cable for the easy entry facility -5- at the seat pan frame.
Installing
Install in reverse order, paying attention to the following:
  WARNING
t  Heed the safety regulations for pyrotechnic components → Chapter.
t  Before handling pyrotechnic components (for example to plug in the connector), the person concerned must „discharge static“, for instance by briefly grasping hold of the door striker plate.
  Note
Make sure the connectors are pressed on as far as they will go and are heard to engage.
  WARNING
The battery must be connected with the ignition switched on. If pyrotechnic components (airbag, belt tensioner for example) are inexpertly repaired, this may result in unwanted triggering after connecting the battery. There must not be anyone in the vehicle when connecting the battery.
–  With the ignition switched on, connect the battery earth wire → Electrical system; Rep. gr.27.
  Note
If the airbag warning lamp -K75- indicates a fault following installation, the event recorder must be interrogated, erased and then interrogated again → Vehicle diagnostic tester.
Notes on installation: For example tightening torques, component replacement → Chapter.
  A72-11323

Replacing seat pan frame > < Exploded view of Easy Entry facility