audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing cover for backrest fitting > < Removing and installing trim on sill panel side

A1

Removing and installing backrest adjustment knob
Removing and installing backrest adjustment knob
Special tools and workshop equipment required
   
t  Assembly tool -3399-
  W00-0165
Removing
–  Move the front seat as far forwards and upwards as it will go.
–  Turn the backrest adjustment knob -1- until a fastener can be seen from the rear -arrow A-. Use a torch if necessary.
–  Engage the assembly tool -3399- at the fastener and prise off the knob -arrow B-.
–  Give the backrest adjustment knob a further 120° turn and repeat the procedure.
–  Detach the backrest adjustment knob.
Notes on installation: For example tightening torques, component replacement → Chapter.
  A72-11327

Removing and installing cover for backrest fitting > < Removing and installing trim on sill panel side