A1
| Exploded view of backrest |
| 1 - | Seat pan |
| 2 - | Sleeves |
| q | Removing and installing → Chapter |
| q | Clip into backrest fitting |
| 3 - | Bolt |
| q | Self-locking |
| q | Replace |
| q | Clean the tapped holes for the bolts using a tap for example |
| q | 24 Nm |
| 4 - | Cover on tunnel side |
| q | For backrest fitting |
| q | Removing and installing → Chapter |
| q | Lug at front of cover must engage in backrest fitting |
| 5 - | Backrest |
| q | Removing and installing → Chapter |
| 6 - | Backrest cover panel |
| q | Removing and installing → Chapter |
| q | Press on until heard to engage |
| 7 - | Upper trim section |
| q | For backrest release mechanism |
| q | Removing and installing → Chapter |
| q | Position at backrest cover panel and press on until heard to engage |
| 8 - | Backrest release handle |
| q | Can be replaced with front seat in position |
| q | Removing and installing → Chapter |
| q | Slide on and press home the handle |
| 9 - | Lower trim section |
| q | For backrest release mechanism |
| q | Removing and installing → Chapter |
| q | Installation position: »TOP arrow mark« facing upwards |
| q | Position at backrest frame and press on until heard to engage |
| 10 - | Retaining clip |
| q | For backrest release handle |
| q | Replace |
| 11 - | Knob |
| q | For lumbar support |
| q | Removing and installing → Chapter |
| q | Position the knob at the lumbar support and press on until it is heard to engage |
| q | Replace knob if it is loose following installation |
| 12 - | Knob |
| q | For backrest adjustment |
| q | Position the knob at the backrest adjuster and press on until it is heard to engage |
| q | Replace knob if it is loose following installation |
| q | Removing and installing → Chapter |
| 13 - | Cover on sill panel side |
| q | For backrest fitting |
| q | Removing and installing → Chapter |
| q | Lug at front of cover must engage in backrest fitting |
| 14 - | Bolt |
| q | Self-locking |
| q | Replace |
| q | Clean the tapped holes for the bolts using a tap for example |
| q | 24 Nm |
| 15 - | Wiring harness |
| q | From side airbag to connector point |
| q | Depending on equipment version there may also be additional wiring harnesses, e.g. backrest heating |
