A1
| Exploded view of „Denso“ air conditioner compressor pulley - version „1“ |
Note| This type of pulley is installed e.g. on vehicles with air conditioner compressor version „7 SEU 16“. |
| 1 - | Bolt |
| q | Replace |
| q | 20 Nm |
| 2 - | Drive plate |
| q | Different versions → Electronic parts catalogue |
| q | Removing and installing → Chapter |
| q | With overload safeguard; tripped in the event of excessive torque (e.g. stiff air conditioner compressor) and the pulley just free-wheels without driving the air conditioner compressor |
| 3 - | Circlip |
| q | Replace |
| q | Ensure correct positioning - flat side facing air conditioner compressor |
| 4 - | Pulley |
| q | Different versions → Electronic parts catalogue |
| q | Removing and installing → Chapter |
| q | The rubber element of the pulley is tripped in the event of excessive torque (e.g. stiff air conditioner compressor) and the pulley just free-wheels without driving the air conditioner compressor |
Note| Under certain conditions (e.g. rough engine running), the rubber element of the pulley may be tripped when there is no air conditioner compressor or refrigerant circuit fault. |
| 5 - | Air conditioner compressor |
| q | Clean the air conditioner compressor drive shaft before fitting the pulley |