Exploded view - hydraulics (LHD)

Make

Audi

Model

A1

Section

5-speed manual gearbox 02R › Clutch, control › Exploded view - hydraulics (LHD)

Power transmissionExploded view - hydraulics (LHD)

Exploded view - hydraulics (LHD) Overview t  → Chapter „Removing and installing clutch slave cylinder“ t  → Chapter „Removing and installing pipe/hose assembly“ t  → Chapter „Bleeding clutch system“

1 -

Bolt

q

2x

q

20 Nm

2 -	Clutch slave cylinder

q	Removing and installing → Chapter

3 -

Gearbox

4 -

Clip

q	To remove and install pipe/hose assembly, pull out clip as far as it will go

5 -

Clip

q	To remove and install pipe/hose assembly, pull out clip as far as it will go

6 -	Brake fluid reservoir

7 -

Seal

q	Not available separately

q	Renew supply hose -item 8- if damaged

8 -	Supply hose

9 -

Seal

q	Not available separately

q	Renew supply hose -item 8- if damaged

10 -	Clutch master cylinder

q	Removing and installing → Chapter „Removing and installing mounting bracket with clutch master cylinder“

11 -

Seal

q	Renew seal if damaged

q	Push onto pipe connection

q	Lubricate with brake fluid before installing

12 -	Pipe/hose assembly

q	Removing and installing → Chapter

q	Disconnecting from clutch master cylinder and clutch slave cylinder → Fig.

13 -

Retainer

q	For pipe/hose assembly

14 -

Dust cap

15 -	Bleeder screw

q	Bleeding clutch system → Chapter

q

6 Nm

16 -

Seal

q	Renew seal if damaged

q	Push onto pipe connection

q	Lubricate with brake fluid before installing

Disconnecting and connecting pipe/hose assembly from/to clutch master cylinder/clutch slave cylinder –  To remove, release clip -3- with a screwdriver and disconnect pipe/hose assembly -1- from clutch master cylinder/slave cylinder -4-.   Note Renew damaged seals -2-. –  Press pipe/hose assembly -1- onto connection on clutch slave cylinder and clutch master cylinder -4- so that clip -3- snaps into place. –  Pull on pipe to check it is secure.

04 Transmission