audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Removing and installing clutch position senderG476 > < Function check for clutch master cylinder and slave cylinder
Exploded view - pedal cluster, clutch master cylinder
   
Exploded view - pedal cluster, clutch master cylinder
1 - Clutch pedal
q   Removing and installing with over-centre spring → Chapter
q   Removing and installing with extension spring → Chapter
2 - Retaining clip
q   Renew only when clutch master cylinder has been removed
q   Removing → Fig.
q   Pressing on → Fig.
3 - Clutch master cylinder
q   Removing and installing → Chapter „Removing and installing mounting bracket with clutch master cylinder“
4 - Gasket
q   Renew
q   Glue onto clutch master cylinder
5 - Clutch position sender -G476-
q   Removing and installing → Chapter
q   Checking in Guided Fault Finding → vehicle diagnostic tester
6 - Pivot pin
q   Cannot be removed without being damaged
q   Always renew
7 - Plenum chamber partition panel
q   With mounting for mounting bracket and master cylinder
8 - Bush
q   For top drilling in mounting bracket
q   Bushes for bottom drilling in mounting bracket are installed in slave cylinder
9 - Nut
q   25 Nm
q   3x
q   Self-locking
q   Renew
10 - Crash bar
q   Secured to steering column
11 - Bolt
q   20 Nm
12 - Mounting bracket
q   Removing and installing with clutch master cylinder → Chapter
q   Removing and installing without clutch master cylinder → Chapter
13 - Stop
q   For clutch pedal
14 - Over-centre spring
q   An extension spring or an over-centre spring is installed depending on the equipment version
q   Select correct components from → Electronic parts catalogue
q   Removing and installing → Chapter
15 - Bearing bushes
16 - Extension spring with vibration damper
q   An extension spring or an over-centre spring is installed depending on the equipment version
q   Select correct components from → Electronic parts catalogue
q   Engaged on mounting bracket → Item and at clutch pedal → Item
q   Removing and installing → Fig.
17 - Cap

   
Removing retaining clip
–  Lever off retaining clip -A--arrow-.
  N30-0024
Pressing on retaining clip
–  Carefully press retaining clip -A- onto operating rod for clutch master cylinder using punch -2074-.
  N30-10290
Removing and installing extension spring
–  Insert vibration damper so that 2nd spring coil -right arrow- is at recess -left arrow- (in illustration) of vibration damper.
  N30-10226

Removing and installing clutch position senderG476 > < Function check for clutch master cylinder and slave cylinder