–
| Unclip clutch position sender -G476--arrows A, B-. |
–
| Unplug electrical connector and remove clutch position sender -G476-. |
Note -Items 1, 2, and 3- can be disregarded. |
Installation is carried out in reverse sequence; note the following: |
–
| Fit clutch position sender -G476- all the way onto clutch master cylinder (electrical connector should be plugged in beforehand). |
l
| Clutch position sender should click into place -arrow A-. |
–
| Check by pulling clutch position sender-arrow B-. |
|
|
|