Audi Workshop Service and Repair Manuals

Removing and installing mounting bracket without clutch master cylinder Special tools and workshop equipment required

t  Pliers -T10005-

Removing –  Remove dash panel trim (driver's side) → General body repairs, interior; Rep. gr.70.

–  Remove bolt -arrow- and detach crash bar.

–  To release operating rod for clutch master cylinder, pull clutch pedal slightly towards passenger compartment. –  Press both sides of retaining clip inwards using pliers -T10005--arrows-.

–  Remove nuts -1 and 2-. –  Carefully remove mounting bracket -3- (to do this, get a second mechanic to counterhold clutch master cylinder until it is disengaged from mounting bracket).

Installing Installation is carried out in reverse sequence; note the following: l  Tightening torques → Chapter „Exploded view - pedal cluster, clutch master cylinder“   Note Renew self-locking nuts. –  Bring clutch pedal into position at clutch master cylinder. l  The retaining clip -2- must be fitted on the master cylinder operating rod -1-. –  Press on clutch pedal so that retaining clip snaps into place in mounting on clutch pedal -3-. –  Install dash panel trim (driver's side) → General body repairs, interior; Rep. gr.70.