A1
| Exploded view - differential |
Note| t | Securing gearbox to assembly stand → Chapter |
| t | Always renew both tapered roller bearings together. |
| t | Adjust differential if tapered roller bearings, differential cage, gearbox housing or clutch housing are renewed → Chapter. |
| 1 - | Countersunk bolt |
| q | 25 Nm |
| q | Screws into threaded piece → Item |
| 2 - | Flange shaft (right-side) |
| q | Do not interchange; left and right flange shafts are different |
| q | For correct version, refer to → Electronic parts catalogue |
| 3 - | Spring for flange shaft |
| q | Installed behind flange shafts |
| 4 - | Thrust washer |
| q | Installation position: lip faces spring |
| 5 - | Tapered ring |
| q | Installation position: Taper towards differential cage |
| 6 - | Circlip |
| q | Holds tapered ring, thrust washer and spring in position when flange shaft is removed |
| 7 - | Sun wheel |
| q | Installing → Fig. |
| 8 - | Threaded piece |
| q | Installing → Fig. |
| 9 - | Differential pinion pin |
| q | To remove, shear off spring pin → Item → Fig. |
| q | Installing → Fig. |
| 10 - | Planet pinion |
| q | Installing → Fig. |
| 11 - | One-piece thrust washer |
| q | Lubricate with gear oil before installing |
| 12 - | Flange shaft (left-side) |
| 13 - | Oil seal for flange shaft (left-side) |
| q | Can be renewed with gearbox in vehicle → Chapter |
| 14 - | Tapered roller bearing outer race |
| q | Pulling out → Fig. |
| q | Pressing in → Fig. |
| 15 - | Tapered roller bearing inner race |
| q | Pulling off → Fig. |
| q | Pressing on → Fig. |
| 16 - | Differential cage |
| q | With riveted final drive gear |
| 17 - | Spring pin |
| q | Secures differential pinion pin |
| q | Is sheared off on removal → Fig. |
| q | Installing → Fig. |
| 18 - | Tapered roller bearing inner race |
| q | Pulling off → Fig. |
| q | Pressing on → Fig. |
| 19 - | Tapered roller bearing outer race |
| q | Pressing out → Fig. |
| q | Pressing in → Fig. |
| 20 - | Shim |
| q | For differential |
| q | Determining thickness → Chapter |
| 21 - | Oil seal for flange shaft (right-side) |
| q | Can be renewed with gearbox in vehicle → Chapter |
| 22 - | Clutch housing |
| 23 - | Gearbox housing |
